Attending an open for inspection can be a daunting task for anyone, no matter how experienced they are.
But one thing you always need to remember is there’s more to a home than its interior design. Try not to let the stunning L-shaped couch or sweeping staircase influence your decision too much.
Remember to take into account the building’s state of repair as much as you judge the layout of the kitchen, or the second bedroom’s en-suite.
If you’re serious about buying the property, it pays to be thorough. A few simple maintenance checks can sometimes be the difference between buying your dream home and stepping into a costly nightmare.
With that in mind, here are ten things to look for at your next open for inspection.
1. Check for water stains, corrosion and mould
Try to look at the walls for any signs of moisture penetration or water leaks, especially near showers and baths. This is not a structural defect but can be costly to repair.
2. Assess ceilings for sagging
Look at the ceilings to see if they have a ‘parachute’ appearance. This can be done by shining a torch across the ceilings, which will show up all deflections and defects in the ceiling sheets.
3. Look inside the cabinets in all wet areas
All cabinets should be opened to see if there is a smell of damp, mould or mildew. Any damp smells can be an indication of water leaks or even rising damp.
4. Check the walls for large cracks
The internal and external walls should be checked to see if there are any large cracks.
Properties with a large number of cracks greater than 2.0mm in width are cause for concern and should be further inspected by a qualified building inspector.
5. Check for mould in bathrooms and bedrooms
Mould can look like harmless clouds on the walls and ceilings, if they’ve recently been cleaned. But finding it should set your alarm bells ringing. Firstly, mould’s bad for your health – by releasing allergens into the air, it can cause allergic reactions and aggravate respiratory health issues, such as asthma – and secondly, it could be the result of a larger issue.
It needs to be cleaned by professional mould remediation companies, who often charge a hefty fee.
6. Check the internal wall plastering for fine cracks
The internal wall plastering can be easily checked for fine hairline cracks (map cracking, as they take on the appearance of a map). These cracks are caused by the incorrect application of the wall plastering at the time of construction.
If they’re found in one area of the property, they’re usually found elsewhere. The plaster can crack further and even come loose, especially when wall fixings for paintings are installed.
7. Look at the external roof lines
Look at the lines of the roof to check if they are straight and free from deflections.
8. Check the roof gutters for rust
The roof gutters may look great from ground level, but checking them from their top side may reveal them to be corroded and in need of replacement.
9. Check the roof downpipes run to storm water drains
Do a quick walk around the external perimeter of the home to check that all roof downpipes are discharging into stormwater soak wells and not just onto the ground.
You should also look for any signs of past flooding or excess water flow around the roof downpipe bases, as this often indicates that the soak wells are not suitably sized or require cleaning out, which can cost an arm and a leg.
Installing stormwater soak wells on an established property can be very expensive, as paving, concrete and garden beds may need to be excavated to install the drains.
10. Look for drain holes on the external perimeter walls
This is particularly important for multi-storey properties. There should be small holes evident above and below window and door frames and along the suspended slab levels. The holes will usually be spaced approximately 1200mm apart. These holes allow water to escape from the cavity walls. Without these holes, water can penetrate the internal walls of the home and cause ongoing and expensive maintenance.
If you’re ever in doubt, ask a professional pest and buidling company to assess the property and write a detailed report on its state of repair.
Source - Realestate.com.au
by Stephen Murace in Top Tips
Archived Posts
- October 2024 (2)
- September 2024 (1)
- August 2024 (1)
- July 2024 (1)
- June 2024 (2)
- March 2024 (1)
- February 2024 (2)
- November 2023 (1)
- September 2023 (2)
- August 2023 (3)
- July 2023 (4)
- June 2023 (4)
- May 2023 (5)
- March 2023 (2)
- January 2023 (3)
- December 2022 (2)
- November 2022 (7)
- October 2022 (7)
- September 2022 (7)
- August 2022 (9)
- July 2022 (13)
- June 2022 (8)
- May 2022 (9)
- April 2022 (3)
- March 2022 (3)
- February 2022 (1)
- January 2022 (2)
- December 2021 (5)
- November 2021 (6)
- October 2021 (6)
- September 2021 (6)
- August 2021 (5)
- July 2021 (5)
- June 2021 (8)
- May 2021 (4)
- April 2021 (5)
- March 2021 (2)
- February 2021 (4)
- January 2021 (6)
- October 2020 (6)
- September 2020 (6)
- August 2020 (10)
- July 2020 (4)
- June 2020 (4)
- May 2020 (2)
- April 2020 (5)
- March 2020 (4)
- February 2020 (7)
- January 2020 (3)
- December 2019 (2)
- November 2019 (2)
- October 2019 (8)
- September 2019 (6)
- August 2019 (3)
- July 2019 (6)
- June 2019 (4)
- May 2019 (8)
- April 2019 (8)
- March 2019 (7)
- February 2019 (3)
- January 2019 (2)
- December 2018 (2)
- November 2018 (1)
- June 2018 (2)
- May 2018 (4)
- April 2018 (2)
- March 2018 (4)
- October 2017 (1)
- September 2017 (1)
- July 2017 (1)
- May 2017 (1)
- March 2017 (1)
- February 2017 (1)
- December 2016 (1)
- November 2016 (1)
- October 2016 (1)
- September 2016 (1)
- August 2016 (1)
- July 2016 (1)
- June 2016 (1)
- May 2016 (1)
- February 2016 (2)
- January 2016 (1)
- November 2015 (2)
- October 2015 (2)
- September 2015 (2)
- August 2015 (1)
- July 2015 (2)
- May 2015 (1)
- April 2015 (2)
- March 2015 (7)
- February 2015 (7)
- January 2015 (1)
- December 2014 (1)
- November 2014 (2)
- October 2014 (2)
- September 2014 (2)
- August 2014 (3)
- July 2014 (6)
- June 2014 (4)
- February 2014 (4)
- October 2013 (1)
- September 2013 (1)
- August 2013 (1)
- June 2013 (2)
- May 2013 (1)
- October 2012 (1)
- April 2012 (1)
- March 2012 (2)
- December 2011 (2)
- November 2011 (4)
- October 2011 (5)
- September 2011 (4)
- August 2011 (3)
- July 2011 (2)
- May 2011 (1)